最新的Cisco CCIE Routing and Switching Written Exam #350-001, v4.0 - 350-001免費考試真題
問題1
Which IGMPv2 message contains a non-zero "Max Response Time"?
Which IGMPv2 message contains a non-zero "Max Response Time"?
正確答案: C
說明：（僅 PDFExamDumps 成員可見）
問題2
Refer to the exhibit.
Cisco 350-001 Exam
Which statement would explain why R4 and R3 are unable to build an EIGRP adjacency?
Refer to the exhibit.
Cisco 350-001 Exam
Which statement would explain why R4 and R3 are unable to build an EIGRP adjacency?
正確答案: A
問題3
Multi Protocol Label Switching (MPLS) is a data-carrying mechanism that belongs to the family of packet-switched networks. For an MPLS label, if the stack bit is set to1, which option is true?
Multi Protocol Label Switching (MPLS) is a data-carrying mechanism that belongs to the family of packet-switched networks. For an MPLS label, if the stack bit is set to1, which option is true?
正確答案: A
說明：（僅 PDFExamDumps 成員可見）
問題4
What needs to be enabled for Unicast RPF?
What needs to be enabled for Unicast RPF?
正確答案: C
說明：（僅 PDFExamDumps 成員可見）
問題5
Which three are needed to run VRF lite for IPv6 on a router? (Choose three.)
Which three are needed to run VRF lite for IPv6 on a router? (Choose three.)
正確答案: A,B,C
說明：（僅 PDFExamDumps 成員可見）
問題6
Which two tunneling techniques support IPv6 multicasting? (Choose two.)
Which two tunneling techniques support IPv6 multicasting? (Choose two.)
正確答案: A,E
說明：（僅 PDFExamDumps 成員可見）
問題7
Which two statements best describe CBWFQ? (Choose two.)
Which two statements best describe CBWFQ? (Choose two.)
正確答案: A,B
說明：（僅 PDFExamDumps 成員可見）
問題8
Which configuration would make an IP SLA probe use a precedence value of 5?
Which configuration would make an IP SLA probe use a precedence value of 5?
正確答案: D
說明：（僅 PDFExamDumps 成員可見）
問題9
Spanning Tree Protocol IEEE 802.1 s defines the ability to deploy which of these?
Spanning Tree Protocol IEEE 802.1 s defines the ability to deploy which of these?
正確答案: C
說明：（僅 PDFExamDumps 成員可見）
問題10
A router is connected to an HDLC circuit via a T1 physical interface. The SLA for this link only allows for a sustained rate of 768 kb/s. Bursts are allowed for up to 30 seconds at up to line rate, with a window Tc of 125 ms. What should the Bc and Be setting be when using generic traffic shaping?
A router is connected to an HDLC circuit via a T1 physical interface. The SLA for this link only allows for a sustained rate of 768 kb/s. Bursts are allowed for up to 30 seconds at up to line rate, with a window Tc of 125 ms. What should the Bc and Be setting be when using generic traffic shaping?
正確答案: D
說明：（僅 PDFExamDumps 成員可見）